Mauzin (Hallade) track measurement car

The measurement and analysis of track geometry is carried out regularly by all the railway infrastructure administrators in order to obtain data from which the track quality is established and the maintenance can be scheduled (Cope – 1993). Historically, the use of track inspection cars can be traced back to the early 1920’s in France…

Chainage creep

When designing multiple line alignments – in railway stations or plain line sections – there will be a creep of the alignment stationing due to the length difference between the alignments. This stationing (or chainage) creep becomes relevant when adjacent alignments have to be kept at the same level or with a well-defined elevation difference.…

Evaluation of the track quality

Track measurement The importance  of  knowing  the  track  geometric  quality  arose  in  the  middle  of  20th  century,  when  European infrastructure managers developed their own track recording vehicles allowing a continuous measurement of track geometry and based on this, their own track geometry quality evaluation standards (EN 13848-6). Periodic track measurement is required to evaluate the…

Maglev Guideway Design

Maglev is a transport system that uses the magnetic levitation to move vehicles without contact to the guideway. The system uses magnetic forces for levitation, propulsion and guidance of the vehicle, thereby making practically negligible the friction forces and allowing very high speeds. The technological evolution is making this transportation system competitive and gaining consideration as a…

Relative position of adjacent tracks

General considerations The relative position of  railway double or multiple adjacent lines is of critical importance for level crossings. On canted tracks, the road traffic is affected if the level crossing does not provide a good riding plane, especially for long vehicles or the (sometimes expensive) low profile ones. This is why the design of…

The orphan rule of cant design over a reverse transition

Motto: Tolle lege. Most of the railway track design standards around the world are presenting the particular issue of the reverse transition. All these standards are insisting on keeping a constant rate of change of curvature – a constant A. By doing this in fact the design will include a single continuous transition between the two opposite circular…

British Railway Track

Another classic book it sure is “British Railway Track Design, Construction and Maintenance”, edited by Geoffrey H Cope and having around 40 contributors for writing the 30 chapters of this essential track compendium. Its last six edition was published in 1993 by The Permanent Way Institution. Presenting the essential principles but also the British specifics…

How is the cant measured?

The good old times Since the early beginnings of the railway, the track engineers were aware of the centrifugal forces influence to the train riding when passing through a curved section of track. To compensate this influence, the track was inclined laterally by creating a positive level difference between the outer and inner rails of a…